Xcceleration

Legacy Turbo Performance Stage1 Kit

(Approximately 285 H.P.) Please note, all power outputs stated are only approximations, for reference purposes and will vary depending on each vehicle, its condition, fuel and modifications.

Turn your Legacy into a 'Performance Car '!

Kit Contains:

Ram Intake: Using the same design feature of the velocity stack found on the inlet to the MAF sensor in the factory box this cast aluminum intake carries the velocity stack radius outward to mate up with a 4.5" high flow cone filter.
Turbo Back Exhaust w/ 3'' Piping into 2.5'' pipe, twin mufflers w/ 3.5'' oval tips. Cutout System Optional, with additional costs.

Ram Intake

Xcceleration Legacy GT 2005

Turbo Back Exhaust

w/ 3'' Piping to 2.5'' Piping

w/3.5'' oval tips!

With

ELECTRIC CUTOUT VALVE

-Never crawl under your car to remove the cap from your cutout -Maintenance free design! -Torrington Needle Bearings for years of trouble free service -High torque gear motor -Plug and play 16GA. Belden Wiring Harness -Small black rocker switch is only .75" X .50"

Xcceleration Legacy GT 2005 Turbo Back exhaust system.

This bolt on system is made out of Stainless Steel tubes and flanges and uses high quality mufflers and tips. The down pipe and mid pipe section, each have a 3 inches diameter and two high flow catalytic converters.

The Cat back then splits in two sections of 2.5 inch pipe to each muffler with 3.5'' oval tips. The driver's side muffler, works with the exhaust system to produce a low mellow exhaust note, for everyday driving and performance.

The system is designed for track days, only working with the electric cutout switch, allowing for the exhaust to exit the exhaust system without any restriction for maximum performance and sound!

* Includes all gaskets necessary for installation.

Hear Mild to Wild

NOTE: Under Federal EPA regulation, replacement of original catalytic converters is allowed only if the original converter(s) is missing, or the vehicle has more than 50,000 miles or is at least five years old and the need for a replacement has been established and documented, or a local inspection program has determined the existing converter is in need of replacement. Please note that no aftermarket catalytic converters are legal for installation in California on OBD II vehicles (some 1994 & 1995, and all 1996 and later vehicles). There is a chance of seeing a CE Light: Inefficient cat code when running less than two cats, so if seen, contact us for the mechanical fix (sold separately). All performance parts have been designed and are intended for off highway application only. Installation of these parts on a vehicle intended for use on public roads may violate state or federal laws and regulations including those relating to emissions requirements and motor vehicle safety standards.

'05+ Legacy Turbo Stage 1 Kit - complete

$2699.99 + shipping

Order Now!

**Note: Please replace the following OEM gaskets when installing the kit: header, uppipe and turbo gaskets. Xcceleration.com highly recommends you install a boost gauge, exhaust gas temperature (EGT) gauge, and air/fuel gauge to monitor your car and ensure safe, reliable performance. Gauges are sold separately